How to Operate the Minolta Freedom 3 Camera

Equipment and Supplies

To get started using your camera, you will need a:

• Minolta Freedom 3 camera
• Roll of 35mm film

Warning:   Different films are for different occasions! Just remember that the 
       	   lower the ISO number (this will be on the film box as 25, 100, 200, 
           400, or 1000), you need more light and less movement. The higher 
           numbers are for taking pictures inside or where there is a lot of 
           activity. 

Before you can begin taking pictures with your camera, you need to put an unexposed roll of film into your camera. This can be done by following these easy steps: (1) opening the back of the camera, (2) putting the film in the camera, and (3) advancing the film.

Opening the back of the camera. This camera will help you load the film. All you need to do is:

1. Turn the camera face down so you are looking at its back with the viewfinder pointing away from you. You will notice the film door covers the entire back of the camera beneath the viewfinder.
2. Find the film door opener on the left-hand side of the door. Push this switch up and the door will swing open.

1. Take the film out of its box and plastic container.

   Warning:   Film producers recommend that the film should be loaded in low light
              levels! this is to protect the film from being exposed before it is 
              put in your camera. Do not pull the film out of the cassette except 
              as indicated below.
   

2. Hold the film cassette so the little inner hub is pointing toward you. Place the film into the left-hand side of the camera. The film will only go in one way so do not force the cassette into place.

1. Hold the cassette in place with your left hand as you pull enough film from the cassette to reach the right side of the camera. Slide this end piece of film aroundthe rubber hub and press the notched holes of the film onto the matching notched teeth of the hub.

2. Locate the clear, plastic door on the right-hand side of the film door. Close THIS door onto the film and hub. The camera will now advance the film. If it doesn't, repeat the previous step.
3. Close the main film door. As you do this, the motor will advance the film to exposure 1. On top of the camera in the center, the display window will now say 1 in the lower right-hand corner.

Now that the film has been loaded into the camera, you are now ready to start taking pictures. The majority of the work is done by the camera, but a few easy steps must be followed to maintain a consistent quality in your pictures. These are: (1) holding the camera, (2) framing the picture, and (3) taking the picture.

Holding the camera. Holding the camera is a very important part of picture taking; an improperly held camera can result in blurred pictures caused by camera movement. To ensure a good picture, you must:

1. Grasp the camera with its front pointing away from you in your right hand so that your index finger is wrapped around the top, right-hand corner of the camera. Your remaining fingers should be in the notch of the lens cover and your thumb should be on the film compartment door.
2. Place the camera into your left palm so it has a flat, sturdy platform to rest on.

   Warning:   Make sure your shoulder strap is held out of the way of the 
              lens.  This can cause pictures to be partially blacked out.
   

1. Hold the camera up to your face with the front facing away from you. Position the viewfinder to the eye that you will be looking through. Close the other eye.
2. Aim the camera at the subject that you will be photographing and look through the viewfinder. You will see a representation of the picture.
3. Center the main item of your picture into the middle of the viewfinder. The white box around the outside edge of the viewfinder is a representation of the outer edge of your picture. If something you want in the picture falls outside this edge, back up to squeeze this in.
4. Make sure the small, inner box in the very center of the viewfinder is on the subject you want photographed. This is the spot where the camera will focus.

Warning:   Failure to center the focusing box on your subject can result in 
           blurred pictures.

1. Make sure that there is nothing, fingers or shoulder strap, directly in front of the camera.
2. Find the shutter release. This square, silver button, located under your right index finger on the top right-hand side of the camera, is what triggers the camera to actually take the picture.
3. Depress the shutter release. Your picture is taken and the film is automatically advanced to the next frame. (The Minolta Freedom 3 automatically adjusts for different lighting situations and turns the flash on automatically when needed.)

Warning:     When taking a picture, if a red light appears in the viewfinder, 
             this means the flash needs a moment to charge itself. Wait a few seconds until a greenlight comes on, then take your
             picture. Failure to wait will result in dark pictures due to lack 
             of light.

After you've finished taking your pictures, you need to get the exposed roll of film out of your camera so that you can get it processed into pictures. This is done by: (1) rewinding the film and (2) removing the cassette.

Warning:  Never open the back of the camera before the film is rewound
          back into its cassette. Doing so will expose the entire roll to light
          which will ruin all of your pictures.

1. Continue to take pictures with your camera as normal. When the film reaches its end, the camera will automatically unlock the advance mechanism and rewind the film.

2. Locate the rewind switch on the bottom of the camera if you want to rewind the film before it reaches the end of the roll. This switch is shaped like the letter L and is labeled with the letter R. Just press this button and the film will rewind back into the cassette.

1. Hold the camera face down.
2. Open the film compartment door by pressing the latch located on the left-hand side of this door.
3. Remove the film cassette from this camera.

   Warning:    About 2 inches of film will stick out of the cassette.  Do
               not pull this out of the cassette. This will expose the film to light
               and ruin any pictures. 
   

4. Hold the cassette in one hand and turn the small hub of the cassette counter-clockwise to roll the remaining film into the cassette. You do not want any film to be left sticking out of the cassette.

Interested in courses related to this page or a printed version? See the resources page.

Return to the main menu of this online textbook for technical writing.